VR or hall sensor which is best
Moderators: jsmcortina, muythaibxr
VR or hall sensor which is best
As I'm rewiring currently for ms2 but plan on an MS3X change in the future. What is best : a VR sensor or a hall sensor. I've read criticism of both.
Re: VR or hall sensor which is best
I would say hall all the way. Just so you have the proper tooth spacing.
Re: VR or hall sensor which is best
What do you mean with "having the proper tooth spacing" ?vw_chuck wrote:I would say hall all the way. Just so you have the proper tooth spacing.
Re: VR or hall sensor which is best
Air gap between the gear tooth sensor and the actual teeth
2000 ZX2 : Sequential COP, MS3 + MS3X + TinyIOx, PWM Returnless Fuel, Flex Fuel, Variable Geometry Intake Manifold, Garrett GTX2863R .82AR housing @ 15 psi
Re: VR or hall sensor which is best
Some people try to use a tiny little tooth wheel with tiny little teeth and they have lots of problems and blame the hall sensor.
-
- Site Admin
- Posts: 39614
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: VR or hall sensor which is best
VR sensors are generally regarded as more accurate at high RPMs, that's why the OEMs use them. Hall sensors can have a time lag on one switching edge. Ford's TFI hall sensor has a delay depending on temperature apparently.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: VR or hall sensor which is best
I was planning on using the Holley 60-2 wheel for SBC.
http://www.summitracing.com/int/parts/hly-556-102.
How difficult would it be to set this up. If more accurate, what VR sensor would be the way to go ?
I currently also use an MSD 8366 distributor. This has one VR sensor. I could potentially use a new reluctor wheel where I cut of all but one tooth. Would it be possible to us that as cam sensor ?
http://www.summitracing.com/int/parts/hly-556-102.
How difficult would it be to set this up. If more accurate, what VR sensor would be the way to go ?
I currently also use an MSD 8366 distributor. This has one VR sensor. I could potentially use a new reluctor wheel where I cut of all but one tooth. Would it be possible to us that as cam sensor ?
Re: VR or hall sensor which is best
I decided to go with a VR sensor and 36-1. This is for a SBC gen 1. What sensor to use ?