I'm not getting any signal from these sensors. I don't see any activity when cranking in the composite, tooth or engine logs. I must be missing something obvious...
Kit car w/ Ford/Yamaha SHO motor.
Pre-assembled MS3.57/MSX
All new wiring.
LS1 coils w/ no other ignition bits.
Looking for sequential ignition.
Existing VR Crank Sensor w/ 36-1 tooth wheel - (Wired to 3.57#24 TACH IN White in shielded wire In 'Crank' Tach input)
Shield and Ground - (Wired to 3.57#1&2)
New Hall Cam Sensor - (Wired to MSX#32 Cam input Dark Green In 'Cam' Tach input)
12V power and ground to sensor ground
Is there something obvious I can check? I have sequential ignition, dual wheel and cam in on MSX CAM enabled. Even if the other settings still need tweaking, shouldn't I get SOME signals when cranking?
Thanks in advance!
Edit: Also, I've checked the VR crank and Hall cam jumpers and pots.
Update: I've probed the signal wires from the cam and crank sensors while cranking. Cam shows 0-12V and the crank sensor shows .4V. It looks like both these sensors are working, but not getting received correctly at the MS. Could this be a faulty unit? I'm attaching the msq.
No cam or crank signal
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 17507
- Joined: Thu Apr 16, 2009 8:08 pm
Re: No cam or crank signal
You need to change the wheel setup to "dual wheel with missing tooth".
Matt Cramer -1966 Dodge Dart slant six running on MS3X
Re: No cam or crank signal
Nice! Now we're getting some data. This was the spark I needed...
I'm going to start looking through the rest of the setup now. Here are the current logs.
I'm going to start looking through the rest of the setup now. Here are the current logs.