MS3 PRO on CBR600 RR

[ilkerozturk58]

Dear Users,

This week, we will setup of ms3 pro harness on 2008 CBR 600RR. I searched forum about 600rr configuration. Some users says, cbr600rr uses Honda RC51 igniton system with stock Cam/Crank wheels. Is it suitable for running engine? Second question about is Trigger angle /offset which is have to set 0 degree or first tooth angle degree from BTDC ?
Dtafast Ecu uses 35 degree first tooth angle. And they gives 60 degree advance at some point, Is this advance too much?

I wait your advices

Thank You

[Matt Cramer]

That should be a good starting point.