Hi i have a question when using the 36-1 crank wheel with the DIY hall sensor do i need to install the jumper across Jp1 position 1 and 2 and J1 position 3 and 4 as they mention in the MS3X manual or this is already done on assembled units?
or do i just need to setup the wheel and sensor and adjust the pots R52 and R56?
Thanks
jumper needed when using diy hall sensor and 36-1 wheel?
Moderators: jsmcortina, muythaibxr
Re: jumper needed when using diy hall sensor and 36-1 wheel?
what version board do you have? 3.0 or 3.57?
-
- Experienced MS/Extra'er
- Posts: 301
- Joined: Fri Nov 23, 2012 3:17 pm
Re: jumper needed when using diy hall sensor and 36-1 wheel?
The threaded sensor has a built in pull up, not needed on the board.
Fastest MS powered vehicle on the planet ! 6.60@208mph
Re: jumper needed when using diy hall sensor and 36-1 wheel?
You always need SOME jumper arrangement to select which tach input circuit is to be used, and how. Now, a pre-built unit that was ordered configured for a Hall sensor and a 36-1 wheel may have the jumpers properly installed and the pots set, but you really should check. It's your time and frustration ...
Temporarily shut down - back soon!
QuadraMAP Sensor Module -- PWM-to-Stepper Controller -- Dual Coil Driver
Coming soon: OctoMAP Sensor Module
TTR Ignition Systems
QuadraMAP Sensor Module -- PWM-to-Stepper Controller -- Dual Coil Driver
Coming soon: OctoMAP Sensor Module
TTR Ignition Systems
Re: jumper needed when using diy hall sensor and 36-1 wheel?
The ecu is the preassembled ms3x 3.57 from diy
-
- Master MS/Extra'er
- Posts: 643
- Joined: Sun Nov 06, 2005 12:31 am
- Location: NORTHERN CALIFORNIA
Re: jumper needed when using diy hall sensor and 36-1 wheel?
you should still open the cover and check that all the jumpers are set to the correct position BEFORE trying to fire up the engine...... its easier to do a quick check and know everything is set up correctly, rather than find out that you burned up something and have to send the board out to get repaired. Old saying an ounce of prevention......
64 el camino, 383 SBC, 11.7 to1 CR, accufab tb/rhs intake, 44lb injectors, trick flow heads, xr292r solid roller cam, belt drive camshaft, dry sump oil system, 2400 stall, turbo 350, spooled 9 inch, strange axles, 3.89 gears, dual wideband, full sequential fuel/cop, MS3x using 1.4.1 code.