Hi,
I have a feauture request. Would it be possible to have a setting that would hold an AE event from happening a set amount of milliseconds after an AE event has taken place.
In other words: I would like to prevent two AE events happening too close after one another.
Is this something that could be considered?
Rene
Feature request: ae hold
Moderators: jsmcortina, muythaibxr
Feature request: ae hold
Rover Vitesse 3.5
MS3 full-sequential
36-1 triggerwheel
Direct coil control
Innovate LC1 wideband lambda sensor
MS3 full-sequential
36-1 triggerwheel
Direct coil control
Innovate LC1 wideband lambda sensor