Traction control input

[hiltonlo05]

Looking for clarification on the switch input for traction control...is it similar to launch where it needs to see ground the entire time it's enabled? The very specific switch I want to use is a momentary (factory button with logo on C6 vette), and wondering if it sending a momentary ground signal to the input would toggle the TC on or off. Otherwise I'll setup a latching relay to allow me to use the button to toggle the relay on and off, thus giving signal to the TC input on the MS3.

Thanks in advance!

[dontz125]

It looks like a temporary button - ON while held down. You -can- set it to 'Always on' by setting [Enable on] to "Off"; not sure if that's actually desirable for 99% of the planet ...