cel error code.

grom_e30 · Post by **grom_e30** » Mon May 30, 2016 9:02 am

im using 1.4.0 firmware, i had my cel light light up and i caught it on a datalog, If looking at 'cel status' i get 8 so a tps fault and this is because the adc count is going over my max setting not a problem. But in the same log the 'Cel Error Code' remains as 0 and i don't think thats correct.

grom_e30 · Post by **grom_e30** » Wed Jun 01, 2016 11:42 am

Well it only outputs the 'cel error code' if you have the light output set to 'flash codes'

Post by **jsmcortina** » Wed Jun 01, 2016 4:09 pm

grom_e30 wrote:Well it only outputs the 'cel error code' if you have the light output set to 'flash codes'

That doesn't sound like expected behaviour.

James

grom_e30 · Post by **grom_e30** » Wed Jun 01, 2016 4:17 pm

Thats how its working for me, i turned on blink codes and 'cel error code' works in the log. i can supply the msq if its needed.

Post by **jsmcortina** » Thu Jun 02, 2016 3:54 am

Yes, please post the MSQ, that makes it easier to duplicate the behaviour on the bench.

James

grom_e30 · Post by **grom_e30** » Thu Jun 02, 2016 10:37 am

the only change between no 'cell error code' in the datalog and it working was changing the light output from solid to flash codes in check engine settings.

jasaircraft · Post by **jasaircraft** » Fri Jan 20, 2017 6:53 am

how did this go?

grom_e30 · Post by **grom_e30** » Fri Jan 20, 2017 7:22 am

edit:

i'm still running 1.4.0 i had a quick peek through the later releases and there are no notes mentioning a fix for this, so i guess that this one got forgotten about

Megasquirt Support Forum (MSEXTRA)

cel error code.

cel error code.

Re: cel error code.

Re: cel error code.

Re: cel error code.

Re: cel error code.

Re: cel error code.

Re: cel error code.

Re: cel error code.