Ok in my instructions it states to run jumper wire from PE1 to Spark G. Now my Shift input is PE1 which is a grounding switch aka horn button. is this normal ? seeing I only ground it to shift what does or will it affect. I have been logging by hitting start logging before a run and not using air shift and logs good that way now. since now running and getting dialed in i need to use air shifter.
thanks in advance
Derek
Logger output
Moderators: jsmcortina, muythaibxr
Logger output
Comp65/65 Hayabusa on meth. 358rwhp @7.3psi xxxrwhp@37psi
-
- Site Admin
- Posts: 39619
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Logger output
What instructions are these?? I don't see that in the Manuals (link above.)
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".