40 degree in egt

[racerron]

8bit.msq

i have the ms3x with a diyautotune 8 channel can-egt. when the engine is off and key on my egts are at around 46 degrees f. in tuner studio. which is low. air temp today 85 f. now when i open the can-egt temps are also is 46 degrees f. which is to low. the only to make the egt temps right is to change the ADC resolution to 8 bits then the temps are real (87-90). is there a ADC resolution setting (8,10,or 12 bits) in the regular tuner studio to make the egts right?

[racerron]

10bit.msq

on the bottom of page 8 it says Current MS3 firmware
requires setting this to 10 bits. this makes the TS to show low temps.

[racingmini_mtl]

Please post the entire project, not just the msq. Use the 'Create Project Backup' option in the vehicle projects menu.

Using 8 bits is definitely not the way to go so the issue is something else.

Jean

[racerron]

it says the extension tsproj is not allowed. it seem to take a while to load before the message showed up. im thinking it is to large.

[racingmini_mtl]

Change the extension to ".zip"

Jean

p.s. James, if you read this please change the forum properties to accept the .tsproj files.

[racerron]

i don't know to do a zip file. i never done one.

[racerron]

thanks to youtube you can learn to do a zip file.

[racingmini_mtl]

It's not the tsproj file but only an msq. What is needed is the tsproj file.

Jean

[racerron]

Sorry I guess I'm not very computer savvy. Maybe when I get home today I can have a friend of mine help me with it

[racerron]

http://s000.tinyupload.com/?file_id=065 ... 4164856120
try this

[racerron]

try this

[jsmcortina]

James, if you read this please change the forum properties to accept the .tsproj files.

Hopefully that's in place now.

James

[racerron]

i tried loading it and it still says file is to big.

[racerron]

hear is my can-egt file. still can't load zip project file. it says it's to big.

[jsmcortina]

Have you discussed this with DIYAutoTune.com support? I saw you asking about this on Facebook also. Cross-posting blurs the issue.

The default settings on the CANEGT work with MS3 without change if you follow the manual and/or load in the canegt MSQ that is provided with the MS3 firmware zip.

James

[racerron]

Yes I did discuss it with DIY I talked to a a guy named Ben any said my settings look good and sorry about it posting this twice but I'm I guess I'm just trying to figure out why my egt's are lower than they should be. I'm thinking maybe I need to reinstall the firmware.

[racerron]

good news. i got the readings to read the same (can-egt and tuner studio). something must have been wrong with firmware. reloaded it and