Injector setup ID1000's

[B1ack_Mi16]

Downloaded the ID1000 specs from Injector Dynamics website

2016-12-14 08_00_31-ID1000_Megasquirt_Data.xlsx [Beskyttet visning] - Excel.jpg

I already entered the dead time of 1.069ms and the stated flow rate in the basic fuel calculations.
Also filled in the offset-multiplier table in in the injector dead time/pwm table.

But what do I use the "Small Pulse EPW / New EPW" values for?
I don't really understand what it means.

[Paul_VR6]

There is another table for small pw

[CRSTune]

The settings are located in Fuel Settings -> Injector Small Pulsewidths.

For an article by Injector Dynamics describing what low pulsewidth or non-linear pulsewidth is, check out this link:
http://injectordynamics.com/articles/low-pulse-tech/

[B1ack_Mi16]

Found it... just silly of me that I didn't see it the first time. Data inplace and engine finally started ;)