Do I need the Bosch 211 Ignition Module?

HustleNono · Post by **HustleNono** » Sat Feb 04, 2017 5:04 pm

I am working on hooking up a 2007 CBR600RR's ignition coils to the MS3 Expansion card. I know that for the MS2 you needed to use a bosch 211 ignition module.... is one still needed for the MS3? thanks

Matt Cramer · Post by **Matt Cramer** » Mon Feb 06, 2017 8:59 am

Two wire coils will need some sort of driver module.

HustleNono · Post by **HustleNono** » Mon Feb 06, 2017 3:54 pm

Matt Cramer wrote:Two wire coils will need some sort of driver module.

Hey Matt, thanks for the reply! I did some reading and I think I understand now. My question is, the diagram for the Bosch 211 and MS that I'm looking at shows that the 4 ignition coils are connected into a wasted spark configuration, but I am looking at doing a sequential firing. Can I do this with the Bosch 211? If you have any links that I could read up on my own to gain some info it would be very helpful, as this is all very new to me. Thanks again.

Post by **jsmcortina** » Mon Feb 06, 2017 4:00 pm

Read the MS3 Hardware Manual.

James

Megasquirt Support Forum (MSEXTRA)

Do I need the Bosch 211 Ignition Module?

Do I need the Bosch 211 Ignition Module?

Re: Do I need the Bosch 211 Ignition Module?

Re: Do I need the Bosch 211 Ignition Module?

Re: Do I need the Bosch 211 Ignition Module?