Ms3 pro boost controller questions
Moderators: jsmcortina, muythaibxr
Ms3 pro boost controller questions
How would one go about setting up ms3 pro boost controller to run a fill and vent solenoid setup for co2? Some like the boost leash and other high end boost controller's are able to do. I'd like to be able to set the map I want in the table and let Ms control the duty cycle time based boost would be great as that's what I'm use to running thanks
-
- Super MS/Extra'er
- Posts: 2639
- Joined: Tue Sep 14, 2004 4:17 pm
- Location: Aberdeen, Wa
Re: Ms3 pro boost controller questions
If my memory is correct. Download the current release, 1.5.0 and in the file is a supplemental PDF that goes over the co2 setup, wiring and plumbing
Volvo 940, 2jzge, MS3Pro, daily
240Z, 2JZ, MS3Pro boost control
240Z, 2JZ, MS3Pro boost control
-
- Super MS/Extra'er
- Posts: 17507
- Joined: Thu Apr 16, 2009 8:08 pm
Re: Ms3 pro boost controller questions
You'll need to be on the 1.5.0 code. Use the dome pressure control settings and use two high current outputs, one for each solenoid.
Matt Cramer -1966 Dodge Dart slant six running on MS3X
Re: Ms3 pro boost controller questions
What size restrictors are recommended for this?
it mentions it here http://www.msextra.com/doc/pdf/Boost-supplement-1.5.pdf
page 8 section 2.2
it mentions it here http://www.msextra.com/doc/pdf/Boost-supplement-1.5.pdf
page 8 section 2.2
2000 ZX-12R LSR turbo Worlds Fastest at 266.5MPH on board video here https://www.youtube.com/watch?v=CruXgKKzBUs