Cam signal fault

General support questions and announcements for MS3. See also MS3 manuals.

Moderators: jsmcortina, muythaibxr

Post Reply
Darragh791
MS/Extra Newbie
Posts: 9
Joined: Mon Nov 11, 2013 5:47 pm

Cam signal fault

Post by Darragh791 »

Im trying to run sequential injection on my vauxhall c20xe using the standard hall type sensor, all is wired in correctly i think but i a am getting a cam fault can anyone point me in the direction of the problem. Thanks
Last edited by Darragh791 on Mon Apr 24, 2017 2:14 pm, edited 1 time in total.
grom_e30
Super MS/Extra'er
Posts: 4451
Joined: Thu Mar 08, 2012 12:44 pm
Location: UK

Re: Cam signal fault

Post by grom_e30 »

that log shows no cam signal at all, have you adjusted the pots on the ms3x card correctly?
1990 bmw 320i daily driver with m20b25 ms3 sequential fuel, 380cc injectors, d585 coil near plug, home made cam sync, launch control, fan control, vss, homebrew egt logging what's next????
Darragh791
MS/Extra Newbie
Posts: 9
Joined: Mon Nov 11, 2013 5:47 pm

Re: Cam signal fault

Post by Darragh791 »

I am unsure if i logged it correctly there, i redone the log with the spark mode changed check and see if its ok now.
grom_e30
Super MS/Extra'er
Posts: 4451
Joined: Thu Mar 08, 2012 12:44 pm
Location: UK

Re: Cam signal fault

Post by grom_e30 »

you can use log crank and cam, or leave it set for dual wheel with missing tooth. is the cam signal meant to be a single tooth?
1990 bmw 320i daily driver with m20b25 ms3 sequential fuel, 380cc injectors, d585 coil near plug, home made cam sync, launch control, fan control, vss, homebrew egt logging what's next????
Darragh791
MS/Extra Newbie
Posts: 9
Joined: Mon Nov 11, 2013 5:47 pm

Re: Cam signal fault

Post by Darragh791 »

yeah its meant to be a single tooth
rickb794
Super MS/Extra'er
Posts: 6155
Joined: Sun Dec 21, 2008 10:28 am
Location: Portland OR

Re: Cam signal fault

Post by rickb794 »

Did you get this sorted?

I am in the same situation...
Correctly identify your MS ecu here
Read the Do's and Don'ts to avoid the common pitfalls before starting your install or asking for help
Use only these manuals other manuals may cause brain damage or worse.
grom_e30
Super MS/Extra'er
Posts: 4451
Joined: Thu Mar 08, 2012 12:44 pm
Location: UK

Re: Cam signal fault

Post by grom_e30 »

rickb794 wrote:Did you get this sorted?

I am in the same situation...
id start a new thread posting the tune and a composite log
1990 bmw 320i daily driver with m20b25 ms3 sequential fuel, 380cc injectors, d585 coil near plug, home made cam sync, launch control, fan control, vss, homebrew egt logging what's next????
Post Reply