MAT Air dens table

General support questions and announcements for MS3. See also MS3 manuals.

Moderators: jsmcortina, muythaibxr

MAT Air dens table

Postby glowryder » Sun Jul 23, 2017 5:22 pm

I read in the help that 1.3 and earlier there is an embedded correction. I am trying to understand what the "earlier" means. Im running 1.4.12 beta (soon to upgrade to 1.5 prod) and I want to make sure if I set all of this to 100% , that there is still an embedded curve working in the back ground.

Experienced MS/Extra'er
Posts: 345
Joined: Tue Feb 09, 2010 11:54 am

Re: MAT Air dens table

Postby LT401Vette » Mon Jul 24, 2017 6:55 am

1.3 and earlier would mean < 1.4.
So 1.0, 1.1, 1.2, 1.3

In 1.4+
There is a "MAT Air Density Table" selection under "Basic/Load Settings".
This way you can edit it.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
Support the firmware running your engine:
User avatar
Super MS/Extra'er
Posts: 10453
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC

Return to MS3 General Support

Who is online

Users browsing this forum: No registered users and 3 guests