MAT Air dens table

General support questions and announcements for MS3. See also MS3 manuals.

Moderators: jsmcortina, muythaibxr

Post Reply
glowryder
Master MS/Extra'er
Posts: 401
Joined: Tue Feb 09, 2010 11:54 am

MAT Air dens table

Post by glowryder »

I read in the help that 1.3 and earlier there is an embedded correction. I am trying to understand what the "earlier" means. Im running 1.4.12 beta (soon to upgrade to 1.5 prod) and I want to make sure if I set all of this to 100% , that there is still an embedded curve working in the back ground.

Thanks
LT401Vette
Super MS/Extra'er
Posts: 12697
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC
Contact:

Re: MAT Air dens table

Post by LT401Vette »

1.3 and earlier would mean < 1.4.
So 1.0, 1.1, 1.2, 1.3

In 1.4+
There is a "MAT Air Density Table" selection under "Basic/Load Settings".
This way you can edit it.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
Post Reply