I read in the help that 1.3 and earlier there is an embedded correction. I am trying to understand what the "earlier" means. Im running 1.4.12 beta (soon to upgrade to 1.5 prod) and I want to make sure if I set all of this to 100% , that there is still an embedded curve working in the back ground.
Thanks
MAT Air dens table
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 12733
- Joined: Sat Jul 16, 2005 8:07 am
- Location: Moorseville, NC
- Contact:
Re: MAT Air dens table
1.3 and earlier would mean < 1.4.
So 1.0, 1.1, 1.2, 1.3
In 1.4+
There is a "MAT Air Density Table" selection under "Basic/Load Settings".
This way you can edit it.
So 1.0, 1.1, 1.2, 1.3
In 1.4+
There is a "MAT Air Density Table" selection under "Basic/Load Settings".
This way you can edit it.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html