This is an issue that I've had since initially installing the Ultimate in my car. All Analog inputs will give the correct reading with KOEO, but when the engine is running, they will all flicker to a value of "0.0" simultaneously. I have 6 sensors, and they have different voltage ranges, so when they all have a value of "0.0", that means the ECU is interpreting different voltages for each sensor - this tells me it is not a 5v supply or ground issue. I have tested both 5v and sensor ground at the sensor plug when the issue is occuring and both are consistently good. Some of the sensors share the same 5v as the TPS - which shows no problem. Because of these reasons, I do not seem like a wiring issue - it seems more like something internal to the ECU.
I have attached my tune file and datalog. Firmware 1.5.1.
The datalog has a sensor "lag" of 80%, but the problem still shows with a lag of 15%.
Thanks
MS3 Ultimate - Analog inputs go to 0 periodically
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39617
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: MS3 Ultimate - Analog inputs go to 0 periodically
You have enabled knock debug data. See the tooltip, this will over-write the sensor values.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: MS3 Ultimate - Analog inputs go to 0 periodically
Is there a scheduled "fix" for this? We really, really need this in outpc more than wb02 13-16, egt 13-16 and knock 12-16.
The man behind MS Labs
2005 Audi A3 2.0L TFSI DSG AWD - Extreme MS3
2002 Mazda Miata 1.8 6sp - Enhanced MS3 1.4.0, sequential injection, sequential ignition, big turbo, lots of boost
2005 Audi A3 2.0L TFSI DSG AWD - Extreme MS3
2002 Mazda Miata 1.8 6sp - Enhanced MS3 1.4.0, sequential injection, sequential ignition, big turbo, lots of boost
Re: MS3 Ultimate - Analog inputs go to 0 periodically
yesReverant wrote:Is there a scheduled "fix" for this? We really, really need this in outpc more than wb02 13-16, egt 13-16 and knock 12-16.
Best looking and most advanced CAN-bus gauge
Toyota Supra 7MGE, 7M-GTE and 1JZ-GTE Plug and play ECUs: http://www.perfecttuning.net
Serial to Bluetooth or Serial to WiFi
DIYAutotune Canadian, EFI Source and ECUMaster reseller!
Toyota Supra 7MGE, 7M-GTE and 1JZ-GTE Plug and play ECUs: http://www.perfecttuning.net
Serial to Bluetooth or Serial to WiFi
DIYAutotune Canadian, EFI Source and ECUMaster reseller!
Re: MS3 Ultimate - Analog inputs go to 0 periodically
That was an easy fix... Thanks for the quick reply.jsmcortina wrote:You have enabled knock debug data. See the tooltip, this will over-write the sensor values.
James