I am using an Autometer #2259 sensor for my transmission temp. It is a 1-wire thermistor type and need to know if there is an input that allows me to set up the thermistor calibration points.
Thanks
Thermistor Question
Moderators: jsmcortina, muythaibxr
-
- Master MS/Extra'er
- Posts: 449
- Joined: Tue Jun 29, 2010 5:53 am
Thermistor Question
Scottie
Turbo LS Volvo 244
8.746 @ 154.94
Turbo LS Volvo 244
8.746 @ 154.94
-
- Site Admin
- Posts: 39618
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Thermistor Question
1 wire sensors can suffer from ground offsets if there is any ground potential difference.
Firmware 1.4.x and earlier allow calibration of CLT, MAT temperature curves.
Firmware 1.5.x allows "custom#1" temperature curve in addition.
James
Firmware 1.4.x and earlier allow calibration of CLT, MAT temperature curves.
Firmware 1.5.x allows "custom#1" temperature curve in addition.
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
- Master MS/Extra'er
- Posts: 449
- Joined: Tue Jun 29, 2010 5:53 am