i have MS-pro installed on BMW M50 engine running 60-2 crank wheel and half moon hall cam sensor , i have always a 2 pulse cam sensor and the car give cam fault and do not run sequential mode , whatever setting i do it do not work , rising,falling,poll level. nothing work
i attached a tooth logger log to show my tooth pattern
BMW M50 Cam sensor fault
Moderators: jsmcortina, muythaibxr
BMW M50 Cam sensor fault
- Attachments
-
- cam tooth logger.csv
- (115.6 KiB) Downloaded 34 times
-
- Super MS/Extra'er
- Posts: 17507
- Joined: Thu Apr 16, 2009 8:08 pm
Re: BMW M50 Cam sensor fault
This looks like it ought to work on one edge even with it giving two pulses. Can you post the MSQ?
Matt Cramer -1966 Dodge Dart slant six running on MS3X
Re: BMW M50 Cam sensor fault
the cam sensor is hall effect , and the cam tooth is half moon
- Attachments
-
- Basemap.msq
- (272.76 KiB) Downloaded 48 times
-
- MS/Extra Newbie
- Posts: 9
- Joined: Wed Nov 01, 2017 4:54 pm
- Location: the Netherlands
Re: BMW M50 Cam sensor fault
esso
i got the same thing with my M62
that is a 4 tooth cam triggerwheel
but what happens if you change in the "Ignition settings", "spark mode" from Toothed wheel to Log crank&cam?
see my tooth log's in the attach
i got the same thing with my M62
that is a 4 tooth cam triggerwheel
but what happens if you change in the "Ignition settings", "spark mode" from Toothed wheel to Log crank&cam?
see my tooth log's in the attach
- Attachments
-
- log crank and cam.png (125.95 KiB) Viewed 506 times
-
- log cranking.png (109.61 KiB) Viewed 506 times