TunerStudio Version = TunerStudio MS v3.0.28
Firmware Version = MS3 pre-1.5.1 beta 3
Hello,
I am installing a MS3PRO EVO on a 2013 Ford F-150 Coyote Engine. Per the wiring diagram, two of the cam sensors are VR and two are Hall. In tuner studio, I assigned the CAM2 input Digital Frequency In 1. Assuming this is one of the VR sensors, do I wire this to Digital Input Frequency 1 VR+ and, if so, will ECU automatically switch to that input?
Kind Regards,
Mark
Cam Sensor wiring - Hall vs VR
Moderators: jsmcortina, muythaibxr
Cam Sensor wiring - Hall vs VR
- Attachments
-
- 2017-11-06_22.47.58.msq
- (285.39 KiB) Downloaded 40 times