MS3x Crank No Start

General support questions and announcements for MS3. See also MS3 manuals.

Moderators: jsmcortina, muythaibxr

MS3x Crank No Start

Postby HaydEn » Sun Dec 10, 2017 12:32 am


Ended up being a dodgy oem connector for the coil pack.

Hi all,

I have been chasing my tail on this issue for a little while now.

About a month ago the car ran, rough and untuned, but it still ran enough i could take it around the block. The only thing that i have changed is i added my nitrous solenoids as per the Manual.

Now it just cranks over, has an occasional starter kick back, has intake backfires and only once i have been able to get it to run with constant throttle.

I have tried adding and taking timing out of both the ignition map and the cranking map. Added and subtracted fuel. Used different wheel options as well as increasing and decreasing Tooth angle deg.
Cranking no Start
(80.8 KiB) Downloaded 7 times
One and only start
(335.34 KiB) Downloaded 5 times
Tooth log
25198910_1750596134952786_1069272690_o.png (121.64 KiB) Viewed 53 times
MS/Extra Newbie
Posts: 1
Joined: Thu Dec 29, 2016 9:15 pm

Return to MS3 General Support

Who is online

Users browsing this forum: No registered users and 3 guests