grom_e30 wrote:S12C-JS9 i think that is for 12v for the stepper motor driver chip.
DaveEFI wrote:That jumper is usually installed early on as it is more tricky with the processor socket in place. There should also have been a warning about not installing it if an MS1 chip is to be used. Likely why it is an option, rather than hard wired.
jsmcortina wrote:Install the jumper.
billr wrote:I gotta ask... why are you trying to load MS2 firmware when all else indicates you have an MS3???
sjl008 wrote:billr wrote:I gotta ask... why are you trying to load MS2 firmware when all else indicates you have an MS3???
I actually have both, multiple kits ready, kinda personal inventory I've got from DIYautotune. (I'm not associated with them fyi...) just convenient. Best way to learn (Me) is by doing) Today I'll need to build the "ignition interface circuit as instructed in the manual sect 18.104.22.168 if nissan's 3-wire coils are of the high current draw(I don't think they are BUT must chk first.)
Legit question billr.
I'll go to my MS3x after I learn the MS2x way of COPs....I've done the MS3x on the VK V8 nissan motor so I know it works fine.
Lotta wiring on this particular motor regardless of 'WHOs' standalone system you buy, I have MS2extra that I spent 5 hours fiddling around with my laptop and software to get right so I want to "hear the thing run".... that will re-motivate me and know tangible results are around the corner. Again....
jsmcortina wrote:Logic coils take a positive pulse.
High current coils take a grounding pulse.
Your software setting must match up with the coil driver wiring you use.
Users browsing this forum: No registered users and 2 guests