Hi!
Just finished my MS3X v3.0 and running on JimStim.
In TunerStudioMS, I observed that battery voltage readings are 10.4v, when the power supply delivers 11,34v to the JimStim?
Do I have an issue in the elektronics?
Low voltage readings in TS, an issue?
Moderators: jsmcortina, muythaibxr
Low voltage readings in TS, an issue?
-MS3X, (V3 PCB) 1.2 RC 1 firmware. Controlling a light modified Audi 1.8TQ AEB 20v engine with Holset HE221W turbo, 299.4 HP and 400Nm at the hubs in Dynapack.
-
- Site Admin
- Posts: 39612
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Low voltage readings in TS, an issue?
There is a protection diode on the JimStim which drops a volt or so. Therefore you aren't too far off.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: Low voltage readings in TS, an issue?
Ok Nice to know.
-MS3X, (V3 PCB) 1.2 RC 1 firmware. Controlling a light modified Audi 1.8TQ AEB 20v engine with Holset HE221W turbo, 299.4 HP and 400Nm at the hubs in Dynapack.