Hello, new guy here from Comox, BC, Canada. I just assembled my ms2 v3.0 board and i hit a bit of a snag with the wiring for my bip373 coil drivers. The writup in the documents section says i need to jump in a wire with a 330 ohm resistor from IGBTin to the top of r26, but what i am wondering is do i need to jump one to r27 and r29 as well? or is it only to the top of r26 on the back of the board? on the front i already have my drivers mounted and they each have their own 330 ohm resistors anyways.
Hopefully ive made sense here and ill try to add some pics if i can figure out how o.O
Cheers!
ms2 v3.0 6 cyl wasted spark
Moderators: jsmcortina, muythaibxr
-
- MS/Extra Newbie
- Posts: 10
- Joined: Mon Oct 27, 2014 7:53 pm
-
- Site Admin
- Posts: 39612
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: ms2 v3.0 6 cyl wasted spark
Please read the MS2/V3.0 Hardware manual from the "Manuals" link above.
The information you need is on this page http://www.msextra.com/doc/pdf/html/MS2 ... .3-69.html and following.
James
The information you need is on this page http://www.msextra.com/doc/pdf/html/MS2 ... .3-69.html and following.
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
- MS/Extra Newbie
- Posts: 10
- Joined: Mon Oct 27, 2014 7:53 pm
Re: ms2 v3.0 6 cyl wasted spark
i think i figured it out, i was just overthinking it! Its way simpler than i thought it would be is all. Thanks for nudging me the right way