can you place a single resistor on the 12v feed side and then just return back to the ms3x like a high z injector would be? since it will be in sequential mode anyway, wouldn't the resistor only see load from 1 injector at a time? or do I need to put one resistor per injector?
i'm looking at this from a packaging stand point is why i'm asking.
might would make it easier to troubleshoot also....thinking out loud on this part though...
thanks for the input in advance!!
Mark
ms3x low z injector resistor placement question
Moderators: jsmcortina, muythaibxr
-
- Helpful MS/Extra'er
- Posts: 52
- Joined: Mon Apr 28, 2008 6:26 pm
-
- Site Admin
- Posts: 39617
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: ms3x low z injector resistor placement question
It needs to be one resistor per injector. Like this:
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
- Helpful MS/Extra'er
- Posts: 52
- Joined: Mon Apr 28, 2008 6:26 pm
Re: ms3x low z injector resistor placement question
man, I got to do 8 of those things......
james, ya killing me.........lol.....down another week....
thanks for the quick reply sir!!
james, ya killing me.........lol.....down another week....
thanks for the quick reply sir!!
-
- Super MS/Extra'er
- Posts: 6828
- Joined: Sun May 15, 2011 11:41 am
- Location: Walnut Creek, Calif. USA
Re: ms3x low z injector resistor placement question
Even with sequential, more than one injector is on at many times. At high engine loads an injector will be open for much of the 720 deg. in a 4-stroke cycle.