table switching vs flex fuel sensor
Moderators: jsmcortina, muythaibxr
table switching vs flex fuel sensor
if i have a ms3x im assembling. im upgrading form a ms1 which peter florance installed a table switch pin 3 on the db37 plug which is spare 1 on the 3.0 board.my question is could i un solder that and add a flex fuel sensor? would that do the same as a table switch?
-
- Super MS/Extra'er
- Posts: 1341
- Joined: Mon Sep 05, 2011 1:20 pm
Re: table switching vs flex fuel sensor
Yes. Table switching in MS2,3 can be software controlled, you won't need a hardware switch.
Graduate of EFI University.
I build, repair, install and tune Megasquirt systems in North Dakota and beyond!
I build, repair, install and tune Megasquirt systems in North Dakota and beyond!