Does anyone know the LED voltage I need for the LED in the calibration circuit on one of these? Trying to get it going tomorrow and don't want to wait on another one from Innovate.
Thanks a bunch.
Tyler Q
Innovate LC-1 Calibration Circuit LED
Moderators: jsmcortina, muythaibxr
-
- Helpful MS/Extra'er
- Posts: 106
- Joined: Sat Jul 07, 2012 8:18 am
- Location: Cypress (Houston), Texas
Innovate LC-1 Calibration Circuit LED
Tuning in Houston, TX area
https://www.racebushings.com
https://www.racebushings.com
Re: Innovate LC-1 Calibration Circuit LED
From the LC-1 manual, page 5:
8. Optionally connect a indication LED (1.2-2.2V, 1-30mA is recommended) between the
calibration wire and ground.
Hook the calibration wire to the anode. The cathode goes to ground. Therefore, the LED gets its power (and signal) from the calibration wire. You don't need to supply any other voltage.
8. Optionally connect a indication LED (1.2-2.2V, 1-30mA is recommended) between the
calibration wire and ground.
Hook the calibration wire to the anode. The cathode goes to ground. Therefore, the LED gets its power (and signal) from the calibration wire. You don't need to supply any other voltage.
Brian
MS3-3X v1.3.0; TS Ultra 3.0.28; 911SC 3.0L; 3.2 intake; 2 Spartan O2 sensors; LS-2 coils; 60-2 geartooth and hall; dizzy hall
MS3-3X v1.3.0; TS Ultra 3.0.28; 911SC 3.0L; 3.2 intake; 2 Spartan O2 sensors; LS-2 coils; 60-2 geartooth and hall; dizzy hall
-
- Helpful MS/Extra'er
- Posts: 106
- Joined: Sat Jul 07, 2012 8:18 am
- Location: Cypress (Houston), Texas
Re: Innovate LC-1 Calibration Circuit LED
I must have missed that part of the manual. Exactly what I was looking for. Thank you, Brian.
Tuning in Houston, TX area
https://www.racebushings.com
https://www.racebushings.com