seting up an output with rpm between 2 rpms
Moderators: jsmcortina, muythaibxr
-
- Helpful MS/Extra'er
- Posts: 54
- Joined: Thu Jan 24, 2008 11:07 pm
seting up an output with rpm between 2 rpms
hey all, im looking at a way to control the vanos on a 97 bmw 328i. it just uses a 12+ signal, but needs to come on at 1500rpm, and off at 5000rpm (possibly different numbers but thats not important for this). so i know ill need to setup a relay control, thats not a problem, im trying to figure it out in the programmable outputs but drawing a blank. I can get it to come on at a certain rpm, but if i set a condition to turn it off then all i get is a flash when it crosses the 2 rpm points and wont stay on between them. anyone have any tips on this setup in tunerstudio? thanks
-
- Site Admin
- Posts: 39587
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: seting up an output with rpm between 2 rpms
Set it to be ON when
RPM > (low limit)
AND
RPM < (high limit)
James
RPM > (low limit)
AND
RPM < (high limit)
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
- Helpful MS/Extra'er
- Posts: 54
- Joined: Thu Jan 24, 2008 11:07 pm
Re: seting up an output with rpm between 2 rpms
Ok I think that's how I had it set but I might have them in the opposite order, which must screw it up. I'll try that tonight on the sim. Thanks!
-
- Site Admin
- Posts: 39587
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: seting up an output with rpm between 2 rpms
If you get stuck..
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
- Helpful MS/Extra'er
- Posts: 54
- Joined: Thu Jan 24, 2008 11:07 pm
Re: seting up an output with rpm between 2 rpms
Ok no problem, thanks for the help!