Hey all,
I have been reading everything I can but am still a bit confused. I have a megasquirt 2 v3.0 that I wish to build and run msextra on. I am unclear where to find and which instructions to use.
Thanks in advance, Benn
P.S. looking forward to this!
Instructions
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39618
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Instructions
Click on the "Manuals" link above.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
-
- MS/Extra Newbie
- Posts: 3
- Joined: Thu May 05, 2016 6:15 am
Re: Instructions
I have clicked on the manuals link and red through the setup section and on about page 50 or so it tells me the assembly instructions are in the hardware section. I have been through that also but can't find anything there either. Any further help appreciated and sorry to be stuck before i begin!
Cheers, Benn
Cheers, Benn
Re: Instructions
1990 bmw 320i daily driver with m20b25 ms3 sequential fuel, 380cc injectors, d585 coil near plug, home made cam sync, launch control, fan control, vss, homebrew egt logging what's next????
-
- MS/Extra Newbie
- Posts: 3
- Joined: Thu May 05, 2016 6:15 am
Re: Instructions
Thank you so much gentlemen, i didn't expect assembly instructions to be after 184 pages of how to setup and use. I guess that goes to show the value of reading things from start to finish!
Thanks again, Benn
Thanks again, Benn
Re: Instructions
Perhaps the majority buy MS ready assembled, so will have no interest in assembly instructions. But there is an index anyway.bennwilliams wrote:Thank you so much gentlemen, i didn't expect assembly instructions to be after 184 pages of how to setup and use. I guess that goes to show the value of reading things from start to finish!
Thanks again, Benn
Rover SD1 3.5 EFI
MS2 V3
EDIS
Tech Edge O2
London UK.
MS2 V3
EDIS
Tech Edge O2
London UK.