Hi guy's i have a problem to set the good voltage on R54 (2.5v).
I have just finish to built my MS3X and test them with a 12v with 1A (not justim),
So i would know if just plug the MS to 12v is sufficient to adjust the voltage with R56 or if i need to put the Hall sensor (that i will use) to have voltage on R54.
Because i don't have issue on R54 with just 12V.
Thanks for your help.
How to have 2.5v on R54 (adjusting R56)
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39617
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: How to have 2.5v on R54 (adjusting R56)
There should be no problem doing that.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: How to have 2.5v on R54 (adjusting R56)
Effectively at final it run perfectly. Thanks