Route CAN bus to MS3X
Moderators: jsmcortina, muythaibxr
Route CAN bus to MS3X
I'm curious if it's possible to route the CAN H and CAN L lines to unused lines on the MS3X DB37. As of now, I have CAN bus set up using the standard jumpers, but would like to use the MS3X because it would make packaging a bit easier in my application. Any help would be appreciated.
1986 Ford Mustang SVO 2.3L turbo
-
- Site Admin
- Posts: 39615
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Route CAN bus to MS3X
There aren't any unused wires on the MS3X connector, so no.
James
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".