Tach input.

Ask questions about DIY board assembly issues, fault finding and testing. (Covers all Megasquirt versions and board.)

Moderators: jsmcortina, muythaibxr

Post Reply
DaveEFI
Super MS/Extra'er
Posts: 4175
Joined: Sun Apr 15, 2012 12:55 am
Location: SW London, UK

Tach input.

Post by DaveEFI »

Am repairing an MS2 V3. At the same time, am changing it from B&G to Extra Code. It has the VR input missing, but has been running EDIS using the opto input just fine for years.

Question is, do I have to mod the opto input to the Extra schematic, or will it be OK staying as is with the B&G version for EDIS?
Rover SD1 3.5 EFI
MS2 V3
EDIS
Tech Edge O2
London UK.
Matt Cramer
Super MS/Extra'er
Posts: 17499
Joined: Thu Apr 16, 2009 8:08 pm

Re: Tach input.

Post by Matt Cramer »

You can use the same hardware configuration as long as you keep the same ignition input capture setting you were using before.
Matt Cramer -1966 Dodge Dart slant six running on MS3X
DaveEFI
Super MS/Extra'er
Posts: 4175
Joined: Sun Apr 15, 2012 12:55 am
Location: SW London, UK

Re: Tach input.

Post by DaveEFI »

Matt Cramer wrote:You can use the same hardware configuration as long as you keep the same ignition input capture setting you were using before.
Thanks Matt. Perhaps I should change it so as not to confuse anyone somewhere down the line?
Rover SD1 3.5 EFI
MS2 V3
EDIS
Tech Edge O2
London UK.
Post Reply