Hi, I'm almost finished making my harness to install my MS3X.
I want to use an output to light the OEM check engine light (ground to light). What is the best output to use for this?
I have MS3X board, with knock module installed. most outputs are unused.
I was going to use FIDLE, can this output be programmed to output CEL?
Is it better to keep FIDLE for something like water injection and use a lower current output for check engine lamp?
Thanks
Dan
What is the best output to use for Check Engine Light? (MS3X
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 1424
- Joined: Mon Oct 17, 2011 7:28 pm
- Location: South Western Ontario
Re: What is the best output to use for Check Engine Light? (
Any of the outputs that are selectable for CEL duties are the best ones to use.
Tha Toy: 1973 Datsun 240Z Turbocharged, and loads of fun, now MS'd
Tha Otha Toy: 1923 T-bucket Hot Rod, Currently Sniper'd
Tha Daily: 2005 Chevy Blazer
Tha Summer Daily: 1987 Buick Skyhawk hatchback
Tha Long Term Project: 1985 GMC S-10 Jimmy, hasn't been fun for a while
Tha Otha Toy: 1923 T-bucket Hot Rod, Currently Sniper'd
Tha Daily: 2005 Chevy Blazer
Tha Summer Daily: 1987 Buick Skyhawk hatchback
Tha Long Term Project: 1985 GMC S-10 Jimmy, hasn't been fun for a while
-
- Super MS/Extra'er
- Posts: 17507
- Joined: Thu Apr 16, 2009 8:08 pm
Re: What is the best output to use for Check Engine Light? (
FIDLE isn't a particularly high current output. It will work fine here.
Matt Cramer -1966 Dodge Dart slant six running on MS3X
Re: What is the best output to use for Check Engine Light? (
Ok thanks.
That's one more down then, only vss, external air temp and a couple of others to figure out now
Cheers
That's one more down then, only vss, external air temp and a couple of others to figure out now
Cheers