hello. to start, this is my first time setting up a management system with megasquirt, but i have worked with a car that already had it installed.
I'm using MSII with the 3.57 board, and running EDIS ignition on a V8 engine. I'm using a Ford 36-1 wheel, with a standard Ford VR pickup.
To start, I had troubles finding out how to set up the 3.57 board to work with EDIS, if someone has a proven method, please let me know!
the issue: I'm getting rpm signal for about 2 seconds, and then it throws an "RPM not synced" code. I'm glad that it's at least getting a signal for a short period of time, but would like it to get a constant signal. perhaps someone can explain what exactly is happening. picture attached.
Thanks in advance!
RPM not synced. but works for 2 seconds
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 4122
- Joined: Fri May 07, 2004 3:33 am
- Location: Australia
Re: RPM not synced. but works for 2 seconds
If you are using the extra code this is the manual section. http://www.msextra.com/doc/pdf/html/MS2 ... 4-110.html
The picture shows too little.
Use the forum help page if you don't know how to post these files.
The picture shows too little.
Use the forum help page if you don't know how to post these files.
Find the Manuals up top under Quick links: Manuals.
Cheers Luke
Cheers Luke