How do I connect D16 to SPR3 on a 3.57 board?
Ultimately, I'm just trying to get the Bypass wired up for a GM DIS. I could wire the bypass wire direct to TPS VREF instead, but if it's easy enough to get D16 to SPR3, I'd just do that.
Thanks,
-Dave
3.57 D16 --> SPR3 ?
Moderators: jsmcortina, muythaibxr
-
- Master MS/Extra'er
- Posts: 789
- Joined: Sun May 02, 2004 5:55 pm
- Location: Cleveland, Ohio
- Contact:
3.57 D16 --> SPR3 ?
'70 Chevelle ZZ383/700r4/3.73 MS3X, 36-1, LS Coils, Holley Stealthram -- success story
'92 Saturn 1.9 DOHC/5sp, MS3, Champcar racer success story
'79 Malibu DartSHP400/80mm/PG/3.55, MS3X/36-1/LS Coils -- success story
Porsche 944 S2 3.0 -- MS3X/36-1/LS Coils, 1:44s Mid-Ohio, Pro Course
'92 Saturn 1.9 DOHC/5sp, MS3, Champcar racer success story
'79 Malibu DartSHP400/80mm/PG/3.55, MS3X/36-1/LS Coils -- success story
Porsche 944 S2 3.0 -- MS3X/36-1/LS Coils, 1:44s Mid-Ohio, Pro Course
-
- Site Admin
- Posts: 39621
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: 3.57 D16 --> SPR3 ?
This is covered in the Hardware manual. The GMDIS section refers to section 6.4 for internal customisation.
http://www.msextra.com/doc/pdf/html/MS2 ... 4-107.html
James
http://www.msextra.com/doc/pdf/html/MS2 ... 4-107.html
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".