needle not in center of gauge (shadowdash)

For discussion of other tuning and logging softwares

Moderators: jsmcortina, muythaibxr

needle not in center of gauge (shadowdash)

Postby red-racing » Mon Jul 17, 2017 11:01 pm

I have designed a dashboard in tunerstudio 3.0.22, and uploaded to samsung galaxy tab A, shadow dash 1.5.02.

The problem is, Im adding a new a new standard gauge, shows up fine in TS, but when Im uploading to shadowdash, the needle is not in center of the gauge.
Its offset up and right. this drives me crazy. whats the fix for this?
Last edited by red-racing on Tue Jul 18, 2017 3:12 am, edited 1 time in total.
red-racing
Helpful MS/Extra'er
 
Posts: 59
Joined: Fri Jul 31, 2015 4:30 pm

Re: needle not in center of guage (shadowdash)

Postby red-racing » Mon Jul 17, 2017 11:20 pm

found out that this only happens if I use other needle picture on the gauge.
If I just pick a gauge style - circle analog gauge. the needle is in center
red-racing
Helpful MS/Extra'er
 
Posts: 59
Joined: Fri Jul 31, 2015 4:30 pm

Re: needle not in center of gauge (shadowdash)

Postby LT401Vette » Tue Jul 18, 2017 6:08 am

Image needles are new to SD, I'll have to look into this and see if SD is getting the angle wrong.
Phil Tobin
EFI Analytics, helping to simplify EFI
Next Generation tuning software.
Supporting all MegaSquirt versions and firmwares.
http://www.TunerStudio.com
http://www.efiAnalytics.com/MegaLogViewer/
Support the firmware running your engine:
http://www.msextra.com/doc/donations.html
User avatar
LT401Vette
Super MS/Extra'er
 
Posts: 10409
Joined: Sat Jul 16, 2005 8:07 am
Location: Moorseville, NC


Return to Other tuning /logging software

Who is online

Users browsing this forum: No registered users and 1 guest