needle not in center of gauge (shadowdash)

red-racing · Post by **red-racing** » Mon Jul 17, 2017 11:01 pm

I have designed a dashboard in tunerstudio 3.0.22, and uploaded to samsung galaxy tab A, shadow dash 1.5.02.

The problem is, Im adding a new a new standard gauge, shows up fine in TS, but when Im uploading to shadowdash, the needle is not in center of the gauge.
Its offset up and right. this drives me crazy. whats the fix for this?

red-racing · Post by **red-racing** » Mon Jul 17, 2017 11:20 pm

found out that this only happens if I use other needle picture on the gauge.
If I just pick a gauge style - circle analog gauge. the needle is in center

LT401Vette · Post by **LT401Vette** » Tue Jul 18, 2017 6:08 am

Image needles are new to SD, I'll have to look into this and see if SD is getting the angle wrong.

Megasquirt Support Forum (MSEXTRA)

needle not in center of gauge (shadowdash)

needle not in center of gauge (shadowdash)

Re: needle not in center of guage (shadowdash)

Re: needle not in center of gauge (shadowdash)