LSX Closed loop idle
Moderators: jsmcortina, muythaibxr
LSX Closed loop idle
I know I have this pretty messed up. I have been playing with this and now when I'm sitting still and tap the throttle a slight bit the rpm increases a bit but takes a little while for it to come back down. Also when driving down the road the stepper will fully close and if I get on the brakes enough to a complete stop it will almost want to stall until the stepper starts opening. They attached datalog is the sitting still and a slight rev.
-
turbo conversion
- Super MS/Extra'er
- Posts: 1281
- Joined: Thu Aug 19, 2010 6:22 pm
- Location: White House, TN USA
Re: LSX Closed loop idle
I see a few things you can change that may help.
Under Idle Control set Power Between Steps to always on.
Under Closed-Loop Idle Settings set Idle Valve Minimum Steps to 40, also set Max Decel Load (%) to 40.
I would also turn off Idle Advance for now, it is not set correctly.
David
Under Idle Control set Power Between Steps to always on.
Under Closed-Loop Idle Settings set Idle Valve Minimum Steps to 40, also set Max Decel Load (%) to 40.
I would also turn off Idle Advance for now, it is not set correctly.
David
1976 Datsun 280Z L28ET Garrett GT35R T3-T04E stage3 50 trim 63 A/R housing custom grind cam 2000-6000 rpm 440cc injectors intercooled 18 lbs. boost
3" exhaust turbo back LC-1 o2 sensor Hallman manual boost controller EDIS 6 ignition batch fire 60mm throttle body 5 spd T5 borg warner 3.54 lsd
3" exhaust turbo back LC-1 o2 sensor Hallman manual boost controller EDIS 6 ignition batch fire 60mm throttle body 5 spd T5 borg warner 3.54 lsd