I could use some confirmation on my injector Dead Time input into Tuner Studio "at 100%".

[Picture 1] I measured my deadtime by running varying duty cycles to create a CC/pulse value and compared that to the PW. The X intercept of that line turned out to be 0.963ms (deadtime) at 12.1 volts for the one shown, the average of the set turned out to be 0.982ms [shown in pic 3].

[Picture 2] I took the voltage correction chart from TS and plotted it to get a linear equation so that I can see the deadtime offset at 12.1v.

[Picture 3] I do not have all of the voltage data points, so I wanted to use the same curve but input what I measured as a known deadtime.

I found that there was a 122% offset at 12.1v, so I divided my 0.982 by 1.22 and got 0.808ms. I used this value, 0.800ms, as my "Deadtime at 100%" value.

.....is that right??