MS3X engine/tranny controler

[tobmag]

Hi.

I know there is a post about this under MS3 already but it seems to be very dead at the moment so I raise the question here instead.
As I see it the possibility to use MS3/X is there but without having counting I/O you can perhaps not run a V8 full seq and COP and at the same time control a 4L80E
I can understand that this might not be top priority since the hardware sales will be reduced but from a customer perspective this would be a huge advantage to have it all incorporated into 1 control unit

So my question is; will there be any work done on this?

BR//Tobmag

[jsmcortina]

I can understand that this might not be top priority since the hardware sales will be reduced but from a customer perspective this would be a huge advantage to have it all incorporated into 1 control unit

So my question is; will there be any work done on this?

BR//Tobmag

I have no plans to do any work on this as it appears it would have a negative business impact.

James