Hi, I’m kinda new to this and I was wondering how you would make a circuit like this on the picture.
Do you use a prototype print board ? Or just make a big clump of wires with tape around it ?
Proto type printboards, how to?
Moderators: jsmcortina, muythaibxr
Proto type printboards, how to?
- Attachments
-
- B7622ED2-2557-46EE-AEB6-C18D827ED457.png (108.04 KiB) Viewed 701 times
Kent
Supra mk3 2jz-gte
Ms3pro ultimate (installing)
Microsquirt trans control (installing)
Denmark
Supra mk3 2jz-gte
Ms3pro ultimate (installing)
Microsquirt trans control (installing)
Denmark
Re: Proto type printboards, how to?
Easiest way to make a one off is stripboard - called Veroboard in the UK.
Rover SD1 3.5 EFI
MS2 V3
EDIS
Tech Edge O2
London UK.
MS2 V3
EDIS
Tech Edge O2
London UK.
Re: Proto type printboards, how to?
If it is just for testing the circuit use a breadboard.
If you make a proto use a pcb and solder it together.
There are lots of types PCB to choose from, search for perfboard of proto pcb.
If you make a proto use a pcb and solder it together.
There are lots of types PCB to choose from, search for perfboard of proto pcb.
Re: Proto type printboards, how to?
It’s not just for testing I’m hoping it’s actually gonna work and be installed in the car
I might be able to borrow a breadboard before final install.
Maybe one of you two can help me out here
I’m gonna be using the schematic I posted, but I don’t need L and the car is alway gonna drive with OD on because I don’t have an OD switch. I only have P R N and D. Can I just remove the wires from OD and L ?
I might be able to borrow a breadboard before final install.
Maybe one of you two can help me out here
I’m gonna be using the schematic I posted, but I don’t need L and the car is alway gonna drive with OD on because I don’t have an OD switch. I only have P R N and D. Can I just remove the wires from OD and L ?
Kent
Supra mk3 2jz-gte
Ms3pro ultimate (installing)
Microsquirt trans control (installing)
Denmark
Supra mk3 2jz-gte
Ms3pro ultimate (installing)
Microsquirt trans control (installing)
Denmark
-
- Site Admin
- Posts: 39618
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Re: Proto type printboards, how to?
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: Proto type printboards, how to?
James maybe you can tell me how to rewire it when I’m not using OD and L
Kent
Supra mk3 2jz-gte
Ms3pro ultimate (installing)
Microsquirt trans control (installing)
Denmark
Supra mk3 2jz-gte
Ms3pro ultimate (installing)
Microsquirt trans control (installing)
Denmark