Traction control using factory 2 wire abs sensors
Posted: Fri Apr 01, 2016 10:28 pm
Ok I have a 06 cobalt with a ms3x ecu I'm trying to look into traction control I have factory 2 wire abs sensors I was thinking using the rear wheels for a VSS signal and using the front hubs for wheel slip but as far as I know it's AC and the ecu can only read DC I need some ideas and information to what I can do I have herd maybe trying to run a HAll sensor for wheel speed but not entirely certain how I would mock up a wheel hub trigger wheel for the sensor I'm trying to build a good drag setup car so traction control, rolling anti lag and eventually I need to figure a way to do boost by gear and build something to tell ecu what gear car is in