My board is no longer functioning and it shows no response when the stim is hooked up , I noticed a trace was burnt leading to the d13 diode so I repaired that with a jumper sill nothing , I tested voltage regulator next , it showed full pass through of voltage over 5volt so I replaced it as well ,still get no function and the d13 diode is getting very hot . Any ideas ?
Sent from my iPhone using Tapatalk
Ms1 v2.2 burning d13 and trace
Moderators: jsmcortina, muythaibxr
-
- Super MS/Extra'er
- Posts: 17499
- Joined: Thu Apr 16, 2009 8:08 pm
Re: Ms1 v2.2 burning d13 and trace
Check if D15 or C15 is shorted.
Matt Cramer -1966 Dodge Dart slant six running on MS3X