2nd trigger and Shift-lightoutput is the same?

youask · Post by **youask** » Wed Aug 24, 2005 5:01 am

If i read correct if you want to use the 2nd trigger input for ignition you have to wire it up to U11/PTC4 . But also if you want a seq-light shiftlight you use the U11/PTC4 as an output?

Is it possible to use it with both if you use a 1k ohm resistor from U11/PTC4

Post by **jsmcortina** » Wed Aug 24, 2005 5:11 am

No.
Use one or the other, not both.
It is impossible for the pin to be an input and an output with a different function at the same time.

James

youask · Post by **youask** » Wed Aug 24, 2005 1:29 pm

ok, then i won't

thx

Fii · Post by **Fii** » Fri Jul 14, 2006 12:45 pm

Is there a possiblity to use both of these features at the same time?
Maybe one of them could be mapped to a different pin? I could not find an appropriate setting in MT, though.