v3.0 ms1/ onboard ignition driver quick ?

[linuxman51]

I'm having trouble figuring out what to jump where, on the ms&s-e site it shows a diagram of an v3 ms1 hooked up to a coil but no mention of what needs to be set on the board in order to achieve this

[jefe]

If your just using the one v921 for pin #36 OUT ON THE db37

JUMPER IGBTOUT>IGN
JUMPER IGBTIN>330 ohm Resistor>TOP OF R26 (CLOSEST TO HEATSINK)

Config LED 14 to Spark A under spark settings

Hopefully someone else will chime in

[jefe]

I replied yesterday, where did my post go?

[jsmcortina]

but no mention of what needs to be set on the board in order to achieve this

It is within the VB921 picture

James