First of all thank-you James for my engine appearing to look like stock efi is managing the engine underneath the hood. Well I can honestly say that sequential COP rocks! I tortured my little 6 cyl 2.5 L turbo on the dyno yesterday and achieved 412 whp and 358 ft. lbs. of torque @ 18psi. One wouldn't have any idea of what this engine is capable of based upon it's idle and partial throttle driveablilty. The engine revs perfectly clean and consistant to 7400 rpm every time. Again thanks James and all other code warriors for all your hard work.
Ryan
I finally met my GOAL!!!
Moderators: jsmcortina, muythaibxr
-
- Helpful MS/Extra'er
- Posts: 40
- Joined: Tue Jun 15, 2004 5:15 pm
- Location: Tampa, FL
-
- Experienced MS/Extra'er
- Posts: 232
- Joined: Tue May 04, 2004 5:46 pm
- Location: Aurora, Ontario
- Contact:
Congratulations. Is the AFR of 10 at 5700RPM intentional?
Got Knock? - see:
Viatrack Printed Circuit Designs (among other things) http://www.viatrack.ca
Viatrack Printed Circuit Designs (among other things) http://www.viatrack.ca
-
- Master MS/Extra'er
- Posts: 497
- Joined: Sat Jun 12, 2004 6:27 pm
- Location: Worcester, MA
- Contact:
-
- Site Admin
- Posts: 39621
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
Nice.
Great to hear that the COP is working well.
James
Great to hear that the COP is working well.
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Re: I finally met my GOAL!!!
Toydoctor72 - sounds like you are running a BMW M50! I am trying to do that! Can you help me out? d*** - notice its a 1JZ, still I could use some guidance on setting up COP on my BMW motor!toydoctor72 wrote:First of all thank-you James for my engine appearing to look like stock efi is managing the engine underneath the hood. Well I can honestly say that sequential COP rocks! I tortured my little 6 cyl 2.5 L turbo on the dyno yesterday and achieved 412 whp and 358 ft. lbs. of torque @ 18psi. One wouldn't have any idea of what this engine is capable of based upon it's idle and partial throttle driveablilty. The engine revs perfectly clean and consistant to 7400 rpm every time. Again thanks James and all other code warriors for all your hard work.
Ryan