Building an MS-1 MSnS-E for a BMW M30 engine, single coil..
Moderators: jsmcortina, muythaibxr
Building an MS-1 MSnS-E for a BMW M30 engine, single coil..
Hey guys in addition to trying to figure out my 6 COP setup, I am building another MS-1 V3 to run MSnS-E (60-2 decode) but the car only has a single coil/distributer. How do I go about setting up the MS hardware to do this properly?
I am troubleshooting just that setup at this very moment. I am using a 60-2 wheel and an electromotive sensor and bracket. I have no tach signal, but the sensor makes an a/c voltage when cranked. Unfortunately I have no scope. I keep hoping to find something setup improperly in the software.
Ben Rogoza
Ben Rogoza
'85 740Ti Volvo
'88 BMW M3
'88 BMW M3
-
- MS/Extra Newbie
- Posts: 19
- Joined: Sat Apr 02, 2005 8:31 am