hey there guys....
i just did the board modification needed for msns but i dont know how to download the code
i downloaded firmware 29q and i unzipped it
on this page
http://www.bgsoflex.com/megasquirtembdown.html
it say to send the .s19 file but thats like tiny,75kb.
another question too, it says
for Version 2.2 put on th Bootloader jumper pin
where is that
does anyone have a pic of that.there seems to be one pin with boot written next to it
any help would be appreciated
as u can tell i am running ms 1 v2.2 and i am planning to use hyperterm...
thanks again
bootloader
Moderators: jsmcortina, muythaibxr
-
- Site Admin
- Posts: 39615
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
There are two pins (or holes) beside each other marked boot.
Don't use that bgsoflex page, see
http://megasquirt.sourceforge.net/extra/setup.html
James
Don't use that bgsoflex page, see
http://megasquirt.sourceforge.net/extra/setup.html
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".