What would happen if you left wheel for stim on?
Moderators: jsmcortina, muythaibxr
What would happen if you left wheel for stim on?
I am using 60-2 wheel decoder - what would happen if I accidentally left teh wheel for stim on? The coils were not hooked up - nor were the injectors. Its just temp sensors, TPS, VR input, wideband... nothing?
-
- Site Admin
- Posts: 39618
- Joined: Mon May 03, 2004 1:34 am
- Location: Birmingham, UK
- Contact:
With no coils or injectors then nothing to worry about.
If they had been connected the injectors would have been firing 20 times too fast and the coils likewise at no particular crank orientation.
James
If they had been connected the injectors would have been firing 20 times too fast and the coils likewise at no particular crank orientation.
James
I can repair or upgrade Megasquirts in UK. http://www.jamesmurrayengineering.co.uk
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
My Success story: http://www.msextra.com/forums/viewtopic ... 04&t=34277
MSEXTRA documentation at: http://www.msextra.com/doc/index.html
New users, please read the "Forum Help Page".
Ok - i was testing to see if i still had RPM signal with the new VB921s all mounted up but remembered that i left stim for wheel on!jsmcortina wrote:With no coils or injectors then nothing to worry about.
If they had been connected the injectors would have been firing 20 times too fast and the coils likewise at no particular crank orientation.
James
DOH