Innovate advanced settings...

All Megasquirt 1 support questions. See also the Documentation

Moderators: jsmcortina, muythaibxr

Post Reply
JSchlappi82
Helpful MS/Extra'er
Posts: 49
Joined: Thu Apr 27, 2006 11:19 am
Location: Holland
Contact:

Innovate advanced settings...

Post by JSchlappi82 »

What settings do i enter here? MS1, MSnSE, V3, Innovate LC-1...

http://members.home.nl/schlappi/Naamloos-1kopie.jpg
cossie_storm
Helpful MS/Extra'er
Posts: 63
Joined: Mon Jan 30, 2006 4:44 pm

Post by cossie_storm »

Im, not sure, but i belive the values you have ther is rigth

dosen't it stands in the manual?
JSchlappi82
Helpful MS/Extra'er
Posts: 49
Joined: Thu Apr 27, 2006 11:19 am
Location: Holland
Contact:

Post by JSchlappi82 »

Couldn't find it in the manual. What the picture shows is the only thing that is described in the manual from Innovate.

I'm not shure what it should give to Megasquirt, low or high voltage, or 2,5 volts for stoch. Or just high impedance. I'm not sure the megasquirt can handle high impedance....
renns
Site Admin
Posts: 1051
Joined: Fri Apr 02, 2004 6:12 pm
Location: Ontario, Canada

Post by renns »

I helped a friend with an LC-1 a couple weeks back. His AFR was jumping around quite erratically in MegaTune, although it did average out to a reasonable value. The analog output was set at continuous during this test. He has since changed to 1/12 averaging, and he reports a much more stable AFR display.

Roger.
1979 Mazda RX-7, running MSnSExtra hi-res 09c for fuel and spark control on a turbocharged, intercooled, and (of course!) injected 13B rotary.
Post Reply